На другом языке
End Grain vs Edge Grain: Which Should I Make and Why?
A side by side comparison of shop time, wood cost, waste, knife wear and failure risk, with a straight recommendation on which construction to build first.
Читать статьюТег: planning
Все статьиНа другом языке
What Are the Steps to Make an End Grain Cutting Board, Start to Finish?
The full sequence from buying 8/4 stock to the first coat of oil, with the numbers each step depends on: strip widths, kerf, cure times, grits.
Читать статьюНа другом языке
How Do I Design a Checkerboard, Brick or 3D Cube Pattern and Figure Out the Strip Widths?
Strip width formulas for the three classic end grain patterns: checkerboard squares, offset bricks and the tumbling block cube, with worked numbers in mm and inches.
Читать статьюНа другом языке
What Is the Real Cost to Make an End Grain Cutting Board?
A line by line breakdown for a 12 x 16 in maple and walnut board: lumber, glue, abrasives, oil, power, blade wear, scrap rate and the hours nobody counts.
Читать статьюНа другом языке
Is There a Free End Grain Cutting Board Design Tool?
CBdesigner, SketchUp Free and board foot calculators each cover one step of the job. Here is what each one does, where it stops, and what fills the gaps.
Читать статью