На другом языке
7 Ways Your End Grain Glue-Up Fails, and How to Prevent Each
The seven failures that ruin an end grain glue-up, each with the physical cause, the number that tells you it is happening, and the fix that stops it.
Читать статьюТег: glue-up
Все статьиНа другом языке
Why Did My Glue Joints Fail on the Second Glue-Up?
Four causes cover almost every failed second glue-up: cupped slices, dead glue, a burnished or dusty face, and pressure applied to a joint that could not close. Each one leaves a different mark.
Читать статьюНа другом языке
Can You Over-Tighten Clamps and Starve the Glue Joint?
Starved joints are real, but hand pressure on flat stock almost never causes them. What the psi numbers mean, what your clamps actually deliver, and what over-tightening really breaks.
Читать статьюНа другом языке
My Board Cracked Along the Glue Line, What Did I Do Wrong?
A crack along the glue line is a starved joint, a hollow mating surface, or two species pulling against each other. Read the failed seam and find out which one.
Читать статьюНа другом языке
What Are the Steps to Make an End Grain Cutting Board, Start to Finish?
The full sequence from buying 8/4 stock to the first coat of oil, with the numbers each step depends on: strip widths, kerf, cure times, grits.
Читать статьюНа другом языке
Why Did My End Grain Cutting Board Warp or Cup After Glue-Up?
The four real causes of a warped end grain board: wet stock, mixed moisture content, ring orientation and one-sided drying, with the moisture numbers that prevent each.
Читать статьюНа другом языке
How Wide Should the Strips Be for the Second Glue-Up?
The crosscut width of each slice becomes the thickness of the finished board. Here is the allowance to add on top of it, and how to size the first panel around it.
Читать статью